Moustache Samedi 29 Trail: suspension setup & specs
The Moustache Samedi 29 Trail is an e-MTB for trail and touring with 150 mm of fork travel and 150 mm at the rear. It is powered by Bosch Performance Line CX BDU37. This page lists the 1 current builds with fork, shock and shock size and gives matching starting values for SAG and tyre pressure.
Calculate the setup for your Moustache Samedi 29 Trail →
All builds
Fork, shock, shock size (eye-to-eye length × stroke) and rear travel, motor, weight and price according to the manufacturer. Wheel size: 29.
| Build | Fork | Shock | Shock size | Rear travel | Motor | Weight | RRP | Calculator |
|---|---|---|---|---|---|---|---|---|
| 150.2 | RockShox PSYLO Silver R (150 mm) | Moustache Magic Grip Control | 205x60 | 150 mm | Bosch Performance Line CX BDU37 625 Wh | 24.5 kg | – | Setup → |
How it compares
On travel, the Moustache Samedi 29 Trail is right where the “e-MTB for trail and touring” category usually is: 150 mm up front against a median of 150 mm from 101 bikes. Front and rear both work with 150 mm of travel. On travel, it slots in between the Moustache Samedi 27 X2 and the Moustache Samedi 29 Game in the Moustache range. The frame is made of aluminium.
Moustache quotes 24.5 kg for the 150.2 build; that is 1.1 kg more than the 23.4 kg median of 49 comparable bikes. It is powered by Bosch Performance Line CX BDU37 with a 625 Wh battery.
Setup notes for this spec
- Air fork (RockShox PSYLO Silver R): the air valve is on top of the left leg under a cap. Change pressure in small steps (about 5 psi (0.34 bar)) and cycle the fork a few times afterwards so the air chambers can equalise.
- Rebound: turn the red RockShox adjuster fully closed first and count clicks from there – that way you can note settings and restore them later.
- Shock (Moustache Magic Grip Control): get on the bike in your normal riding position, step off carefully and read the O-ring. Always cycle the shock a few times after pumping.
- e-MTB: because of the extra weight, start with slightly more tyre pressure – the surcharge is already built into the table below.
Target SAG for the Moustache Samedi 29 Trail
The table converts the recommended SAG percentages into millimetres, so you can check them with the O-ring directly on the stanchion and on the shock shaft. Adjust the air pressure until the value is right. If Moustache specifies its own target SAG for your model, that takes priority.
150 mm fork, 60.0 mm shock stroke (all builds)
| Riding style | Fork SAG | Shock SAG |
|---|---|---|
| XC / touring | 17 % = 26 mm | 24 % = 14.4 mm on the shock shaft |
| Trail | 20 % = 30 mm | 28 % = 16.8 mm on the shock shaft |
| Enduro / rough | 22 % = 33 mm | 30 % = 18.0 mm on the shock shaft |
| Bike park | 20 % = 30 mm | 27 % = 16.2 mm on the shock shaft |
How to measure SAG is explained in our guide SAG setup.
Tyre pressure starting values
Basis: 2.60″ tyre width, tubeless, trail casing, including the e-MTB surcharge. If you run tubes, add about 0.2 bar (2.9 psi); with an insert, about 0.1 bar (1.5 psi) less is enough.
| Ready-to-ride weight | Front | Rear |
|---|---|---|
| 60 kg | 1.40 bar (20 psi) | 1.60 bar (23 psi) |
| 70 kg | 1.52 bar (22 psi) | 1.72 bar (25 psi) |
| 80 kg | 1.64 bar (24 psi) | 1.84 bar (27 psi) |
| 90 kg | 1.76 bar (26 psi) | 1.96 bar (28 psi) |
| 100 kg | 1.88 bar (27 psi) | 2.08 bar (30 psi) |
| 110 kg | 2.00 bar (29 psi) | 2.20 bar (32 psi) |
| 120 kg | 2.12 bar (31 psi) | 2.32 bar (34 psi) |
Air pressure in the fork and shock
You will find a suitable starting pressure on the sticker on the fork stanchion (or on the shock) or in the suspension manufacturers’ setup charts. Our calculator gives you a starting value including rebound for your weight and riding style. What matters afterwards is the measured SAG from the table above.