bikesetting

Bulls Wild Creed: suspension setup & specs

Manufacturer data retrieved on 26 September 2026 · 2 builds · RRP €3,999 – €5,499 · Bike type: Full-suspension MTB

The Bulls Wild Creed is an enduro bike with 170 mm of fork travel and 160 mm at the rear. Here you will find all 2 current builds with fork, shock and shock size, plus matching SAG and tyre pressure starting values.

Calculate the setup for your Bulls Wild Creed →

All builds

Fork, shock, shock size (eye-to-eye length × stroke) and rear travel, weight and price according to the manufacturer. Wheel size: 29.

BuildForkShockShock sizeRear travelWeightRRPCalculator
Wild CreedRockShox ZEB (170 mm)RockShox Super Deluxe Select–160 mm15.7 kg€3,999Setup →
TeamRockShox ZEB Ultimate (170 mm)RockShox Vivid Coil Ultimate–160 mm15.4 kg€5,499Setup →

How it compares

On travel, the Bulls Wild Creed is right where the “enduro bike” category usually is: 170 mm up front against a median of 170 mm from 41 bikes. The rear offers 160 mm, 10 mm less than the front. Among Bulls’s mountain bikes, the Bulls Wild Creed is the model with the most fork travel. The frame is made of carbon.

At 15.4 kg (Team build), the weight is close to the category median of 15.7 kg. Prices for the Bulls Wild Creed start at €3,999 (Wild Creed), below the category median of €4,750. The top build, Team, costs €5,499. Bulls uses RockShox suspension throughout. In total, 2 different forks are used, from the RockShox ZEB to the RockShox ZEB Ultimate. The Team build uses a coil shock (RockShox Vivid Coil Ultimate), so SAG is set with the spring rate rather than air pressure. Worth knowing for heavier riders: the maximum system weight is 115 kg – after about 16 kg of bike, that leaves around 99 kg including kit.

Setup notes for this spec

Target SAG for the Bulls Wild Creed

The table converts the recommended SAG percentages into millimetres, so you can check them with the O-ring directly on the stanchion and on the shock shaft. Adjust the air pressure until the value is right. If Bulls specifies its own target SAG for your model, that takes priority.

170 mm fork (all builds)

Riding styleFork SAG
XC / touring17 % = 29 mm
Trail20 % = 34 mm
Enduro / rough22 % = 37 mm
Bike park20 % = 34 mm

How to measure SAG is explained in our guide SAG setup.

Tyre pressure starting values

For 2.40″ wide tyres, tubeless with a trail casing. With an inner tube about 0.2 bar (2.9 psi) more, with an insert about 0.1 bar (1.5 psi) less. Stock tyres: SCHWALBE Magic Marry Super/ Big Betty Super gravity soft.

Ready-to-ride weightFrontRear
60 kg1.43 bar (21 psi)1.63 bar (24 psi)
70 kg1.55 bar (22 psi)1.75 bar (25 psi)
80 kg1.67 bar (24 psi)1.87 bar (27 psi)
90 kg1.79 bar (26 psi)1.99 bar (29 psi)
100 kg1.91 bar (28 psi)2.11 bar (31 psi)
110 kg2.03 bar (29 psi)2.23 bar (32 psi)
120 kg2.15 bar (31 psi)2.35 bar (34 psi)

Air pressure in the fork and shock

You will find a suitable starting pressure on the sticker on the fork stanchion (or on the shock) or in the suspension manufacturers’ setup charts. Our calculator gives you a starting value including rebound for your weight and riding style. What matters afterwards is the measured SAG from the table above.

Note: all values without guarantee. Specification can vary by model year, frame size and market – if in doubt, the type plate, the manual and Bulls’s information apply. Never exceed maximum pressures.

Sources

More Bulls bikes